Search Results | Clear Search | Previous (in doc) | Next (in doc) | Prev Doc | Next Doc
B.C. Reg. 379/88
O.C. 1742/88
Deposited September 23, 1988
This archived regulation consolidation is current to April 21, 2006 and includes changes enacted and in force by that date. For the most current information, click here.

Assessment Act

Depreciation Of
Industrial Improvements Regulation

[includes amendments up to B.C. Reg. 364/2002]

Contents
1 Interpretation
2 Determining depreciation
3 Maximum depreciation
4 Closure allowances
5 Rounding down amounts
SCHEDULE

Interpretation

1In this regulation

"Act" means the Assessment Act;

"chronological age" means the number of years determined by subtracting

(a)the year in which the plant first commenced operation, or

(b)in the case of an industrial improvement or part of an industrial improvement that was constructed or installed after the plant commenced operation, the year in which the construction or installation of the industrial improvement or part of it was completed

from the year in which the new assessment roll is completed;

"effective age" means the number of years determined by

(a)calculating the total cost of the industrial improvement,

(b)multiplying the chronological age of each part of the industrial improvement by the cost of that part to give the weighted age of that part,

(c)adding the weighted ages of all of the parts of the industrial improvement, and

(d)dividing the sum of the weighted ages by the total cost of the industrial improvements and rounding the quotient up to the next whole year to yield the effective age.

Determining depreciation

2(1)  Subject to the other provisions of this regulation, for the purposes of section 20 of the Act, depreciation of an industrial improvement shall be applied in accordance with the following formula:

depreciation = annual depreciation rate X age

where

(a)"annual depreciation rate" is the percentage rate set out in the Schedule for the category of plant of which the industrial improvement is a part, and

(b)"age" is the chronological age or, where parts of an industrial improvement have different chronological ages, the effective age of the industrial improvement.

Maximum depreciation

3If the depreciation determined under section 2 for an industrial improvement is equal to or in excess of 80%, the depreciation shall be deemed to be 80%.

Closure allowances

4(1)  If the assessor determines

(a)that a plant is closed on or before October 31 of any year and the owner of the plant or a senior executive officer of the corporation that owns the plant confirms in writing that the closure is permanent, or

(b)that a plant has been closed for a minimum of 3 consecutive years immediately preceding October 31 in any year and the owner of the plant or a senior executive officer of the corporation that owns the plant confirms in writing the fact that the plant is closed and the duration of that closure,

the depreciation applicable to industrial improvements that are part of the plant shall, for the purposes of the assessment roll in the succeeding year, be deemed to be an amount sufficient to reduce the actual value of the industrial improvements to 10% of the cost of those industrial improvements.

(2)  If the assessor determines that

(a)a separate industrial improvement within a plant is permanently closed or shut down on or before October 31 in any year and the owner or plant manager of the plant confirms in writing that the closure or shut down is permanent, or

(b)a separate industrial improvement within a plant has been closed or shut down for a minimum of 3 consecutive years immediately preceding October 31 in any year and the owner or plant manager confirms in writing the fact that the industrial improvement is closed or shut down and the duration of that closure or shut down

the depreciation applicable to that industrial improvement shall, for the purpose of the assessment roll in the succeeding year, be deemed to be an amount sufficient to reduce the actual value of the industrial improvement to 10% of the cost of that improvement.

(2.1)  In addition to the requirements of subsection (1) or (2), a confirmation under this section must

(a)be made to the assessor of the assessment area in which the plant is located,

(b)be made by the November 30 next following the October 31 referred to in subsection (1) or (2),

(c)in the case of subsection (1) (a) or (2) (a), specify the date of the permanent closure or shutdown, and

(d)in the case of subsection (1) (b) or (2) (b), specify the commencement date and duration of the closure or shutdown

in order to be effective for the following tax year.

(3)  Subsection (2) applies only with respect to a complete industrial improvement and shall not be applied to a part of an industrial improvement.

(4)  If a previously closed plant or industrial improvement is reopened or reactivated, this section ceases to apply for the purposes of the assessment roll in the succeeding year and depreciation shall be determined in accordance with sections 2 and 3.

(5)  Repealed. [B.C. Reg. 364/2002, s. (b).]

[am. B.C. Regs. 475/92, s. (a); 396/99; 364/2002.]

Rounding down amounts

5The commissioner may round the amount of depreciated value calculated under section 2 or 3

(a)down to the nearest $100, where the value determined is greater than $101 and less than $99 999, and

(b)down to the nearest $1 000, where the value determined is $100 000 or greater.

[en. B.C. Reg. 475/92, s. (b).]

SCHEDULE

[am. B.C. Regs. 303/90; 475/92, s. (c); 271/93.]

INDUSTRIAL IMPROVEMENT DEPRECIATION RATES

(By Category as listed in section 20 of the Act)

  Annual
Rate of
Depreciation
Category
(a)  mining, extracting, beneficiating or milling of metallic or non-metallic ore...........  6.5
(b)  mining, breaking, washing, grading or beneficiating of coal..............................  4.0
(c)  producing of aluminum.................................................................................  3.0
(d)  smelting or refining of metal from ore or ore concentrate..................................  3.0
(e)  producing, manufacturing, processing or refining of petroleum or natural gas.....  3.0
(f)  manufacturing of lumber or other sawmill and planing mill products...................  4.0
(g)  manufacturing of wood veneer, plywood, particle board, wafer board,
hardboard and similar products.....................................................................
 
 4.0
(h)  manufacturing of gypsum board.....................................................................  3.0
(i)  manufacturing of pulp, paper or linerboard......................................................  3.0
(j)  manufacturing of chemicals...........................................................................  4.0
(k)  manufacturing of chemical fertilizer  3.0
(l)  manufacturing of synthetic resins or the compounding of synthetic resins into
moulding compounds................................................................................... 
 
 3.0
(m)  manufacturing of cement...............................................................................  3.0
(n)  manufacturing of insulation............................................................................  3.0
(o)  manufacturing of sheet glass or glass bottles..................................................  3.0
(p)  building, refitting or repairing ships.................................................................  5.0
(q)(i)  loading of cargo onto seagoing ships or barges, including associated cargo
storage and loading facilities..........................................................................
 
 5.0
(ii)  the maritime structure of a grain terminal operation including piers, wharves,
shipping galleries and loading gallery towers used to transport grain from a
grain elevator to seagoing ships or barges, but excluding those things included
in paragraph (q) (iii).......................................................................................
 
 
 
 5.0
(iii)  grain elevators and associated structures.......................................................  2.5

[Provisions of the Assessment Act, R.S.B.C. 1996, c. 20, relevant to the enactment of this regulation: section 20]